key for ~3 seconds until "PV" displays a specific code to enable/disable the ability to change settings Toolots, Inc. Control Modes: PID Control: Set the Proportional Band (P) to a value greater than 0 DV Electrical Products ON/OFF Control: Set the Proportional Band (P) to 0 CNC Electric Error Indicators:
The dedicates a full page to the button functions. Here is your cheat sheet: xta-7000 temperature controller manual
Refer to this table when the XTA-7000 displays an error: key for ~3 seconds until "PV" displays a
The XTA-7000 has a standard 96×96mm square design. The unit is approximately 90mm deep, so ensure there is adequate clearance within your control panel. The panel cutout size is typically 92×92mm, allowing the controller to fit securely. When mounting, be sure to attach the provided mounting brackets to the sides of the unit and tighten them evenly until the controller is snug against the panel. The unit is approximately 90mm deep, so ensure
: A Key Lock function can be enabled to prevent unauthorized changes to the parameters, with settings typically ranging from 0 (all parameters unlocked) to 1 (only Set Point unlocked). Safety and Maintenance XT -7000 TEMPERATURE CONTROLLER | Toolots
This was where most operators gave up. The previous shift had set the controller to "ON/OFF" control mode. The manual described this as the simplest form of control—like a light switch. It turns full power on until it hits the target, then turns off.